How To Repair Galvanized Water Pipe

Repairing galvanized piping, is a unproblematic homeowner plumbing repair: add taps to it just like whatever other pipe. When replacing a union with a T-plumbing equipment, at that place is no need to cut the piping, but if there is no union or this is a leak-repair chore, according to the most referred Fort Worth plumber, cut the pipe will be necessary.

Cut galvanized pipe with a hacksaw tin take a long time, but a reciprocating saw will reduce the job to a few minutes. Cut galvanized pipe results in ends without threads, and in that location's no skillful way to splice in a replacement or a T. To cut out a section of pipe, unscrew the resulting pieces from their respective fittings, and install a new section of non-galvanized pipe. When making changes to a galvanized pipe, it is necessary to have threads to work with.

Although leaks sometimes occur in the wall of a galvanized plumbing equipment, they are more typical at the threads because the threads reduce the thickness of the pipe wall by more than one-half. The type of threads needed for the replacement fitting depends on whether it becomes necessary to discard the fitting (because information technology leaks or information technology is being replaced with a different blazon), or keeping it.

Discarding the fitting leaves male threads on a pipe end that crave a female adaptor, says the professional person Fort Worth plumber. Keeping the fitting leaves female threads requiring a male person adaptor.

Plumbing Pro Tip Of The Calendar week

Tip #1 Make two cuts: ane several inches abroad from the threads and a 2nd at the threads themselves.

Tip #2 Use ii large pipe wrenches to remove the coupling from the pipage.

Tip #3 If the coupling is frozen (rusted on), heat it with a propane torch and then remove information technology. Clean up the threads with a wire castor and rag. Spiral on and hand tighten a female fitting advisable to the replacement pipage. Tighten the fitting with a wrench.

Tip #4 Insert the replacement piping fully into the fitting and tighten it.

Tip #5 Follow the same steps at the other finish of the new pipe, using a fitting with appropriate threads.

Source: http://www.clearwaterplumber.com/basics-repairing-galvanized-pipe/

Posted by: johnsonnatitiong.blogspot.com

Share this post